1
General Mach Discussion / MaxNC 10 on Waveform - No Y-axis movement
« on: December 13, 2008, 05:12:36 PM »
Hi all,
Enabled max-nc 10 wave drive.
I have x control and z control but no y control? What am I overlooking?
-Stepper speed set to match x/z axis
- I noticed that pins/pots - motors have no effect, other then enable disable. Alll 3 axis are enabled. I assume this is normal from other threads
- I also switched back to Maxnc control program on my old pentium and y-axis worked fine. I also swapped wiring to check the stepper and it worked fine. So its not the motor.
Any help would be great.
David
dlb@cogeco.ca
Enabled max-nc 10 wave drive.
I have x control and z control but no y control? What am I overlooking?
-Stepper speed set to match x/z axis
- I noticed that pins/pots - motors have no effect, other then enable disable. Alll 3 axis are enabled. I assume this is normal from other threads
- I also switched back to Maxnc control program on my old pentium and y-axis worked fine. I also swapped wiring to check the stepper and it worked fine. So its not the motor.
Any help would be great.
David
dlb@cogeco.ca