Guest
Show Posts
1
General Mach Discussion / Jog / cursor mystery
« on: November 11, 2015, 09:47:58 PM »
Mach3 turn
GCODE executes both axes just fine.
Fast Jog ok on both axes
MPG ok on both axes
Z slow jog ok both directions
X slow jog in - direction ok
X slow jog in + direction no response, no DRO change.
Config hotkeys shows codes corresponding to cursor keys when I push them.
Have changed keyboards. Have changed PCs. No improvement
Summary, X slow jog in + direction (right cursor) doesn't move carriage or
show on DRO, all else works properly.
Help please! /and thanks /mark
GCODE executes both axes just fine.
Fast Jog ok on both axes
MPG ok on both axes
Z slow jog ok both directions
X slow jog in - direction ok
X slow jog in + direction no response, no DRO change.
Config hotkeys shows codes corresponding to cursor keys when I push them.
Have changed keyboards. Have changed PCs. No improvement
Summary, X slow jog in + direction (right cursor) doesn't move carriage or
show on DRO, all else works properly.
Help please! /and thanks /mark