Hello Guest it is May 10, 2021, 01:17:44 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - ahroest

Pages: 1
General Mach Discussion / Cable connections and EMC
« on: February 01, 2009, 07:00:31 AM »
I think I am not the only one which has problems with EMC disturbtion from the fraquency controller on the PC lines and the power modules of the stepper motors running in the neighbourhood of the ferquency output cables.
What kind of cabling should we use and at what sides has the screening to be connected.
kind regards,

Pages: 1