1
Newfangled Solutions Mach3 Wizards / Newfangled solutions
« on: April 26, 2011, 05:45:00 PM »
Hello,
I have a problem with the Newfangled solutions.
When starting the wizard "Circular hole pattern" drilling, the X Center DRO read's 1.000 mm
When I make X Center is 0 (zero) and Y Center is 0 (zero), save the settings an run
the program, all works well.
When I run the same program another time, the X Center moves to 1.00 mm.
This problem is very inconvenient for me.
I have a problem with the Newfangled solutions.
When starting the wizard "Circular hole pattern" drilling, the X Center DRO read's 1.000 mm
When I make X Center is 0 (zero) and Y Center is 0 (zero), save the settings an run
the program, all works well.
When I run the same program another time, the X Center moves to 1.00 mm.
This problem is very inconvenient for me.