Hello Guest it is March 28, 2024, 03:44:06 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - claydavis

Pages: 1
1
LazyCam (Beta) / Trying to turn
« on: August 14, 2007, 03:31:32 PM »
Hi,  I have evidently got something set wrong some where.  I loaded the example Outside Profile in LazyCam, went through the steps,  and got the result I would expect.  However when I loaded the .tap file into Mach 3 It was a lot different.  It had balls on the ends.  Let me try to attach a picture. Thanks

Pages: 1