Guest
Show Posts
1
General Mach Discussion / Help getting set up
« on: November 13, 2008, 10:49:41 PM »
Hello all,
I just loaded up Mach 3 to give it a try with my mill and have had no luck with getting my motors to move. I watched the getting started and troubleshooting video to check for the common errors. I have been using kCam so I have the port address, port number, and pins correct. I have the E Stop set so it stops flashing at me when I hit reset. I made sure all the check boxes on the first tab in port setup were correct. I tried toggling the active low + high for the step pins. I ran the driver test .exe and it everything looked good. There are no leds lit on the diagnostics tab. What could I be missing? Thanks for any help
I just loaded up Mach 3 to give it a try with my mill and have had no luck with getting my motors to move. I watched the getting started and troubleshooting video to check for the common errors. I have been using kCam so I have the port address, port number, and pins correct. I have the E Stop set so it stops flashing at me when I hit reset. I made sure all the check boxes on the first tab in port setup were correct. I tried toggling the active low + high for the step pins. I ran the driver test .exe and it everything looked good. There are no leds lit on the diagnostics tab. What could I be missing? Thanks for any help