Topics

1

General Mach Discussion / Can someone help with this error

« on: January 19, 2014, 03:36:50 PM »

I have a fully licensed copy of Mach3 and recently installed the latest updates(a week ago). I ran the machine several times after that with no issue. Today I did a couple of jobs and then this error appeared when I clicked cycle start. The machine ran normal after clicking OK on the error. The message appears after the cycle is complete as well. Attached is a picture (I hope) of the error. Thanks in advance.
ERROR, #Expand File not found at:

Chuck

2

General Mach Discussion / step rate

« on: July 18, 2009, 01:12:37 PM »

How do you change the tep rate in Mach3?