Guest
Show Posts
1
General Mach Discussion / I really need help from the Pro's!
« on: March 02, 2011, 09:21:59 AM »
In 2007 I obtained an older but mechanically new router table and changed all the electronics etc. I bought a new controller and steppers etc from Bob Campbell as well as a new computer based on a recommendation from Art. It is a Sound Logic board with Gecko G203 drives and 640 oz motors. It also has a spindle control board installed but I am not using it as I currently use a plain router that I turn on and off with a relay. The version of Mach3 was 2.58. I never got to running well enough to put it into production but now our proprietary production machine is down. I am trying to get this one running and then change over the proprietary router to run Mach3 so as to have common G files.
Problems:
Jerky motion and loss of position. The router will run okay for a while and then make very jerky curves and lose position as well, not necessarily related. A file I have been testing has one drill point and it will feed a the correct rate and when run again it will feed very slowly, feed is unpredictable. I may have the motors configured wrong and when that is fixed I hope to be able to hold accuracy. The x and z are direct drive (~10 tpi) and the y is a belt drive with about a ~3:1 ratio. I use Rhino, VM and XP Pro.
What I have done:
I added ram to a total of 2.5GB from .5, no change.
I optimized as be the info on the support page, no change.
I upgraded to V3.043, noticeably more predictable, after several hours of running the jerky returned, restarted Mach3 no change, rebooted and jerky gone for now, computer on overnight jerky back in the morning, restart Mach3 and jerky gone with no reboot???
What I need:
I have attached my xlm file, can you good fellows who know a lot about Mach3 please look at it and see if you can find any problems with the config and motor tuning? Any ideas about what is going on with the jerky coming and going, as well as feed speeds? I have been without cnc for several weeks and my backlog is becoming a big problem for us! Any help will be very greatly appreciated!
Ian
Problems:
Jerky motion and loss of position. The router will run okay for a while and then make very jerky curves and lose position as well, not necessarily related. A file I have been testing has one drill point and it will feed a the correct rate and when run again it will feed very slowly, feed is unpredictable. I may have the motors configured wrong and when that is fixed I hope to be able to hold accuracy. The x and z are direct drive (~10 tpi) and the y is a belt drive with about a ~3:1 ratio. I use Rhino, VM and XP Pro.
What I have done:
I added ram to a total of 2.5GB from .5, no change.
I optimized as be the info on the support page, no change.
I upgraded to V3.043, noticeably more predictable, after several hours of running the jerky returned, restarted Mach3 no change, rebooted and jerky gone for now, computer on overnight jerky back in the morning, restart Mach3 and jerky gone with no reboot???
What I need:
I have attached my xlm file, can you good fellows who know a lot about Mach3 please look at it and see if you can find any problems with the config and motor tuning? Any ideas about what is going on with the jerky coming and going, as well as feed speeds? I have been without cnc for several weeks and my backlog is becoming a big problem for us! Any help will be very greatly appreciated!
Ian