Topics

1

General Mach Discussion / Motor config page will not open.

« on: March 02, 2008, 04:49:42 PM »

I am in the process of dialing in Mach 3 on the router but can't seem to open the MOTOR CONFIG page from the drop down menu.  Does anyone know why.?  Thanks for any help  Rob

2

General Mach Discussion / need help! new driver wont work with mach 3

« on: October 22, 2007, 10:18:33 AM »

Hi all, was hoping someone might have the answer.  I have been running mach 3 with a xylotex driver bd but it has been stalling out after running for several minutes.  So I am replacing it with a Mechtronics driver board.  I set it up according to it's instruction manual and works great with the kcam that runs the test on it.  But when I hook it to Mach 3, I don't get anything.  I have been over all the settings and nothing looks out of place.  do I need a different post processor,  what setting should I look at??  Please help.  thanks.  Rob