Hello Guest it is October 24, 2021, 10:36:21 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - stankern

Pages: 1
1
I have seen a probe that you place in the spindle head or router that turns the cnc into a scanner is this working ok
do you program mach3 to scan and do the probe results go straight to the computer , the become an *.stl  file how does all this come togther

2
General Mach Discussion / computer causing gorilla cnc glitch
« on: November 28, 2008, 12:34:01 AM »
i seem to have a problem that cannot be resolved .With the cnc machine powered up, turning on the computer (win xp) during booting the cnc machine drives the z axis down by 2.5 to 3 inches( loss of control ).
I have changed all the settings on the parallel port ,changed the cable to the gorilla cnc and tried 3 computers ,problem does not go away and i'm afraid to use the machine as it could damage the z axis or the gantry.i have been shutdown for a week so far.
I don't know what to do

http://www.youtube.com/watch?v=EngUvy3YKAE

3
General Mach Discussion / interference
« on: November 26, 2008, 08:17:06 PM »
has anyone experienced the computer booting and driving the cnc machine z axis 2.5 inches down and on a shutdown the cnc machine z axis clitches about 1/2 inch
Cannot uinderstand ,the printer port is standard and the right address and it is a desktop amd 3500 computer 2 gigs ram xp pro

Pages: 1