1
General Mach Discussion / Z axis is dead
« on: March 30, 2009, 08:33:28 AM »
Hello everyone,
Everything was fine until I started my SyilX4 Mill today and the Z axis is not moving.
The DROs show movement but it doesnt move.
All other axis operate normaly and in manual mode the Z also works fine.
I did not change any settings !
Any ideas on how to solve this?
Everything was fine until I started my SyilX4 Mill today and the Z axis is not moving.
The DROs show movement but it doesnt move.
All other axis operate normaly and in manual mode the Z also works fine.
I did not change any settings !
Any ideas on how to solve this?