Topics

1

General Mach Discussion / Digitizing probe

« on: January 22, 2012, 03:55:10 PM »

Can anyone explain the cause of the message "Probe ignore, activated at call for probe" ?

2

General Mach Discussion / Keling Breakout board

« on: January 22, 2012, 03:50:10 PM »

Has anyone had any experience using the C10 breakout board from Keling Tech?

3

G-Code, CAD, and CAM discussions / Z axis crash

« on: November 23, 2011, 04:36:13 PM »

I am using Bobcad's postprocessor. It inserts the following line into every program "G53 Z0.", which causes the Z axis to plunge down into the table until it crashes (the top of the part is supposed to be zero). What's the purpose of this command? I have to go through every program and delete it before I can run the program.

4

General Mach Discussion / Jog mode

« on: November 06, 2010, 10:13:47 AM »

What can cause the program to remain in jog mode, even when the virtual pendant is not displayed?