Hello Guest it is August 15, 2020, 01:51:17 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - stevec

Pages: 1
1
General Mach Discussion / Tool Path Window Not Displaying
« on: December 29, 2005, 03:28:28 PM »
When I load G-code like roadrunner, and hit the regen toolpath nothing is displayed except the table, size of job. I upgraded to the latest ver of Mach 3 today and still not working. It use to work, what could be wrong? If I start the cycle the part is drawn in the window but only then.

2
General Mach Discussion / Ignore Tool Change
« on: December 09, 2005, 09:19:32 AM »
I am using Mach3 and am a new user. When I go to settings and unmark ignore tool change, all is fine until I shutdown. How do I make this stay off everytime I start up.


Pages: 1