1
General Mach Discussion / Z axis G1 moves get shorter with reduced feed rate
« on: June 14, 2010, 09:06:41 AM »
I am having this problem.
If feed rate is set below 6"/min then G1 move of Z axis gets shorter.
G0 move is fine
X axis does not exhibit this problem.
I am using ver 3.041 trial version.
Can anyone help?
If feed rate is set below 6"/min then G1 move of Z axis gets shorter.
G0 move is fine
X axis does not exhibit this problem.
I am using ver 3.041 trial version.
Can anyone help?