Hello Guest it is March 28, 2024, 12:47:02 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - bluehatt3

Pages: 1
1
Hi I have been using Mach 3 for about a year now and love it.  I have a Enco square column bench mill I have converted to CNC.  I am using some Allen Bradley Ultra 100 servo drives setup in stepper follower mode.   I just put a servo in for the spindle motor and set it up for the same step/direction setup.  The problem I have is that it ramps up nice but when the spindle stop is set it does not ramp down.  It just stops suddenly.  I have a geared head so it is really hard on the gears when running at high speeds.  Is this a setup problem on my part or am I missing something.

Pages: 1