Hello Guest it is August 02, 2021, 09:11:26 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Don C

Pages: 1
1
General Mach Discussion / Tangential cutter
« on: August 17, 2015, 02:33:34 PM »
The newest version of mach3 doesn't lift before prepping the head. It lifts and prepped at the same time. This was fixed in a earlier version but is back not working.
Thanks
Don Clifton

2
General Mach Discussion / Pinout for a ascension controller
« on: July 26, 2014, 12:50:05 PM »
I'm looking for the pinout for a Ascension 1000 controller. This one has 5 gecko 202 drives. Any help would be great fully appreciated.
Thanks
Don Clifton

3
General Mach Discussion / Mach3 running a Shark Pro Plus
« on: June 25, 2011, 06:25:26 PM »
I'm trying to get a Shark pro plus running on Mach3 for a friend but haven't had any luck. I have download and installed the firmware update and the ncpod plugin but Mach does nothing. DRO don't even move. Is there a XML file or something else I'm missing.
Thanks
Don Clifton


4
LazyCam (Beta) / lazycam in turn mode
« on: December 25, 2007, 12:08:04 PM »
 How do you get lazycam to cut a profile in more than one pass?
 Thanks
  Don

5
Video P*r*o*b*i*n*g / setting up cammera and laser
« on: December 01, 2007, 02:00:33 PM »
 How is the camera to laser setup. Is the camera and laser running parallel to the X axis (X axis moving front to back (gantry)). What should the angle be of the camera and the laser. Is there any setup notes yet?
  Don

Pages: 1