Topics

1

General Mach Discussion / Need help

« on: January 11, 2007, 06:41:50 PM »

All the part programs that I load into Mach 3 always come out to where the part is to small to see in the view window. The part is in a Shaded box with a yellow dashed border around it, the part is in the bottom left corner and I guess it's the machine cordinates in the upper right corner. If I were to run this on my machine the part would be way off the table(machines limits). What am I doing wrong.

2

General Mach Discussion / download problems

« on: December 24, 2006, 06:07:52 PM »

I saved mach3 ver2.0.009 update install onto my desktop, but when I go to install it keeps coming up with an error cannot decomprees setup program