Hello Guest it is March 28, 2024, 10:06:56 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Kevin Harpham

Pages: 1
1
General Mach Discussion / Computer will not shut down
« on: January 15, 2007, 03:09:06 PM »
My computer will not shut down by the proper means of clicking on "turn off computer". I left MACH3 open overnight and it tried to go into standby and left a message indicating it was unable too. I went in and set windows to never go into standby and them proceeded to close all windows and shutdown but after clicking on "turn off computer" it shows the desktop as it normally would with no message or anything and never shuts down. I have reopened MACH with no problems and closed it again with no problems, I have run the driver test with and all is stable. Everything appears to be just normal but I can't turn off the computer. I tried to restart and it’s the same thing.

Any ideas?

Kevin

2
Hello, I will soon be receiving a cnc mill with mach 3 and then later some cad/cam software that is still undecided at this time. I will also be purchasing a computer just for this mill. Being brand new at this with zero experience I would like some advise on what is recommended as far as hardware goes along with the best version of XP I should get. For example do I want to avoid AMD processors or are they recommended? XP media or professional or will the home version do?   ???  Or most likely it doesn't matter.

Kevin

Pages: 1