Hello Guest it is October 20, 2021, 05:33:53 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Maxtownshend

Pages: 1
1
General Mach Discussion / Mach ? to control Starturn 5
« on: December 04, 2006, 12:01:18 PM »
Is it anyway possible to control the 8 way toolpost with Mach 4 on a Denford Starturn 5 Lathe or do you still have to stop the lathe and do it yourself as mentioned in the manual?

Pages: 1