Topics

1

General Mach Discussion / Offset table gone

« on: March 28, 2007, 04:56:30 AM »

Hi
My offset table resets to zero (fixture 1 to 6 (G54-G59))  after testing the new relase 061
is there a way to restore it
Thanks

2

General Mach Discussion / mach 3 rev2.031 works OK but mach 3 rev2.060 Feed rate problem

« on: March 27, 2007, 06:38:47 AM »

Hi all
This is my first post.
I use do make my PCBs with mach 3 rev2.031 and every thing was working fine.
today I switch to 060 but feeddrate was reducing gradually from 254mm/min to 50 mm/min (or 10"/min to 1.9"/min) after 5000 program lines.
then I reinstall mach 3 rev2.031 and every thing returns to normal again.
is there any explanation.
here I attach 2 nc pcb files one in inch and another in mm (same problem with both)
thanks