Hello Guest it is November 30, 2021, 08:27:41 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Cooper

Pages: 1
1
General Mach Discussion / Works in KCam, Not working in Mach3
« on: February 28, 2007, 05:28:16 AM »
Dear All,

I bought my cnc controller yesterday and i connect everything as in manual. The board works very well in Kcam (Kcam is explained in manual and i configured this program works very well). But i would like to buy Mach3 and so i need to configure it for Mach3. I took this ss from related softwares :

Mach3 : (Not Working)


KCam : (Works well)


So, what's the point? What is wrong with these configuration?

TIA

Cooper

Pages: 1