Hello Guest it is April 25, 2024, 11:31:31 PM
Profile Guest

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Zaryk

Pages: 1
1
General Mach Discussion / Spindle configuration problem
« on: September 21, 2008, 08:52:28 AM »
Dear friends. Sorry, but my English is not good. I have a problem with Mach PWM spindle control. I use ncPod board and it work perfect. I connect PWM to Digital converter and config Mach. After them I connect voltmeter to PWM converter output (0-10V) and I have controling voltage. If I input in Mach 18000 rpm I view 9.97V on voltmeter. But my spindle max 24000 rpm! Also I input less 8000 rpm then view on voltmeter 0V. I dont find spindle preferences in Mach. Where is I input min and max spindle rpm?

Pages: 1