Topics

1

General Mach Discussion / Spindle output not function

« on: September 19, 2008, 12:27:01 PM »

I to all can´t figured why spindle relay don´t start when i press spindle button and m3 or m5 function. At ports and pins i have set output enable port 1 pin number 2 and in the Spindle Setup tab i unchecked Disable Spindle relays. At the diagnostics everything work fine. The only way that i put it to work is set the Active low on at the outputs tab , but then the only way to stop it is cut the power.Any suggestion?

  Thanks in advance

Marco