1
Newfangled Solutions Mach3 Wizards / cut rectangle wizard
« on: November 28, 2006, 05:06:03 PM »
Hi All,
in the cut rectangle wizard if i do a inside rectangle ,spindle set to cw ,conventional milling the toolpath is clockwise but it also follows a large arc which goes out of the work piece drawn on the screen then when it finally get on course its on the wrong side of work piece.can make it follow correctly by editing the G42 to G41 but it is still goes anti clockwise.if i do the same inside rectangle climb milling it follows correctly just that it goes clock wise.but all in all i think that mach 3 and the new fangled wizards are brilliant and amazing value for money.
Andy
in the cut rectangle wizard if i do a inside rectangle ,spindle set to cw ,conventional milling the toolpath is clockwise but it also follows a large arc which goes out of the work piece drawn on the screen then when it finally get on course its on the wrong side of work piece.can make it follow correctly by editing the G42 to G41 but it is still goes anti clockwise.if i do the same inside rectangle climb milling it follows correctly just that it goes clock wise.but all in all i think that mach 3 and the new fangled wizards are brilliant and amazing value for money.
Andy