Hello Guest it is February 24, 2024, 05:14:42 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - Easy Channel

Pages: 1

I had to do a recovery on my computer because i had a blue screen of deaf.  I did the recovery now my computer does not talk to the router.  I am believing that the port is not set to communicate to the router.  Sorry if this is a simple thing but we had Chad Busey from Denver (Great guy) set this up but cant get a hold of him anymore.  Hope you can help get us up and running.  The program opens up great we just can't communicate to the router.

Thanks in advance

Neil 720-949-0829

General Mach Discussion / X axis is not working
« on: December 13, 2011, 01:43:23 PM »
I was cutting a two d file just simple flat letters on .o40 aluminium and in the middle of the file the x axis stop working.  Have rebooy the software and the the computer and x axis is still not working.  Y and z are fine.  Also the jog rate is the same speed.  It is stuck in the fast position as if I am pressing down the shift key when moving any y or z.  Thanks for the help.  I am using Cut 2d as my g code generater.

Neil  Feel free to call 720-949-0829.

Also looking for a router experrt in the Denver area to do some training in our shop for a day.

General Mach Discussion / Need Help In Denver
« on: September 11, 2008, 03:56:03 PM »
We have just purchased our mach 3 program and new controller for our router.  We are looking for someone to come in and set up our machine and train us on the program.  We are new to the routing and we are only doing 2d cutting for faces and backs for channel letters.  Feel free to call us

Easy Channel Letters
Neil Fancher

Thanks for all the help

Pages: 1