Hello Guest it is March 29, 2024, 08:37:24 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Cassidy

Pages: 1
1
General Mach Discussion / Screen DRO Never Correct On Startup
« on: May 26, 2009, 12:23:11 PM »
Each time I exit and re-start Mach3, the DRO readings are never the same as when I closed the program. They have no relation to the actual location of any axis. I have to write down each axis location before closing the program and then type that setting back in when I re-start.  Drives me scrappies!!!  ??? ::)  Can anyone tell me where and what to set so this will be correct???

Thanks. Cas.

2
General Mach Discussion / Change Rotary Direction??
« on: May 09, 2009, 01:33:24 PM »
I have a Taig DSLS 3000 that I need to change the rotary turn direction on. It turns clockwise and I need it to turn counterclockwise. I'm think this is done in the ports & pins dropdown but I can't find where. Any help appreciated!!! Many Thanks!!! Cas

3
General Mach Discussion / Setting Units
« on: September 08, 2008, 11:41:48 PM »
I know this is so simple!!!

Can someone tell me how and where to set the units in Mach3 so that they STAY as I want them. Each time I start Mach3, the units are in inches. I set them to Metric...run the program and all is fine... but if I close Mach 3 and restart... the units are once again set to inches. Driving me NUTS!!!   Thanks. Cas ::)

Pages: 1