Hello Guest it is August 08, 2020, 11:33:01 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Freff

Pages: 1
1
General Mach Discussion / Very slow jog
« on: November 29, 2008, 03:57:51 PM »
I've done something wrong or inadvertently reset something, but I just can’t figure out what it is. Everything was running fine until I tried to jog to a new position. The machine jogs so slow it's painful. Actual cutting is no problem and it appears to run as normal. The jog rate is set to 100%. I have increased Vel and Acc, the pulse rates and debounce to no avail. I have tried it in both inches and metric, the same.

I'm at a lose to think of anything else at the moment, perhaps someone could help me out with this please.

Thanks Tony

2
General Mach Discussion / Wizard Inaccuracies
« on: September 11, 2008, 04:36:47 PM »
I have just started using Mach3 R2.63 (licensed) with the come with wizards. To get some experience I have started using the wizards, the Circle Cut to be a good starting element. All the settings I entered came out on the work piece Ok except the diameter.

No matter how many times I tried the diameter always come out different to the setting I entered. Not only that they are randomly different. I have tried the circular pocket and the results are the same, always the diameter.

I'm sure that I'm entering all the settings correctly, but I'm possibly missing something. Could someone please point me in the right direction, it's getting very frustrating.

Many thanks
Tony

Pages: 1