Hello Guest it is May 07, 2021, 07:21:10 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - zacharias

Pages: 1
General Mach Discussion / Configure the Mach3 for Proxxon MF70
« on: September 07, 2008, 05:43:47 AM »
Hello guys,

I am a newbie into the cnc and I started when I buying a Proxxon milling machine MF70.
Also I got from www.cnc-plus.de 3 stepper motors and the controller.


I have problems to set with the appropriate values the motor tuning tub.
More specifically
I am using the step resolution per unit at 1600 according the controller manual and
I set the velocity at 5,8 and accuracy 6,5.

I test it with g-code commands and I also observe that I have a loss in about 0.1mm

Has anyone works the MF70 and mach3?

Any suggestions?



Pages: 1