1
General Mach Discussion / Limit / Home Switches
« on: October 04, 2013, 09:33:25 PM »
I switched over to servos from stepper motors and the axis will not back off the limit switches. The breakout board is a CNC4PC-C11, with Geckodriver G320X and a KL34-180-72 servo motor. All limit and encoder wires are shielded.
When the axis go to the limit it stops but can not move it off the limit switch. Any ideas. HELP
When the axis go to the limit it stops but can not move it off the limit switch. Any ideas. HELP