Topics

1

General Mach Discussion / Mach3 Turn Help

« on: March 22, 2009, 01:41:28 PM »

Following are the problem i am facing with mach3 turn i am using uhu drive.

1. As the tool changer work it changes program coordinates randomly but machine coordinates remains 0,0
2. when any limit switch is hit it changes the hotkey direction with the same hot key the machines move in opposite direction
3. It dose not remember the parameter instead of i save the setting
4. in general configuration should i select absolute or increment?
5. can i have screen shot for general config for lathe.

Ahmed

2

General Mach Discussion / Computer Halting due to 4 input Turret

« on: February 22, 2009, 02:24:22 AM »

Hi,

I am facing a strange problem my lathe turret has 10 tool i made a binray 4 bit to select tool when i use only 3 inputs it works fine as soon as i give 4th input to parallel port it halts the system.  I have cheked this on built in parallel port and pci parallel port card it gives same problem. Any sujestion or any one facing same problem.

Regards

Ahmed

3

General Mach Discussion / PID motor tuning

« on: November 15, 2006, 04:12:31 PM »

Hi,

Can we add PID control in motor tuning of MACH using VB code? This will make servo drive simpler.

Ahmed