Hello Guest it is March 29, 2024, 09:04:36 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Drawbar

Pages: 1
1
General Mach Discussion / Input question
« on: January 30, 2007, 12:58:35 PM »
I'm using Mach 3 version 2.0.39.

When I go into Config, Ports & Pins, under the Input Signals tab, there is an input called 'Timing'.  It's way down in the list past all the OEM inputs.  I can't find any info in the PDF about this input.  Can anyone enlighten me on what it does?

Brian

2
General Mach Discussion / Lost my good shortcut
« on: November 13, 2006, 07:18:04 AM »
I am using Mach 2 with much success.  I recently deleted my shortcut from my desktop.  I wanted it back so I created a new one that points to Mach2.exe.  Now when I use it, I have to select which session of Mach to run.  I remember there were originally shortcuts specifically for Mach Turn and Mach Mill.  Is there a switch I can add to the command line of the shortcut to always jump to the Mach 2 Mill session without me having to select it every time?

Brian

Pages: 1