Hello Guest it is August 14, 2020, 07:26:10 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - gianluca1962

Pages: 1
1
General Mach Discussion / what am I doing wrong?
« on: December 03, 2008, 03:23:31 PM »
just upgraded to last .020 release (for turn) and found that in the feed d.r.o. the value is going sky high instead of keeping the programmed feed.
I copyed and paste the old configuration file .xlm from 1.84.02 version, may be this is the problem?

regards gianluca

2
General Mach Discussion / tip radius compensation problem
« on: August 25, 2008, 05:48:11 AM »
Hello Guys,
I am using mach 3 version  R1.84.001 DEMO on a lathe .
I find I cannot use or I am not able to use the tip radius compensation .
When I set the g41 or g42 the tool make an odd movement at any change of direction.
this is an example of program, what am I doing wrong?

(iso 40)

G18
G21
G42
G61
G90
G94
T0101 (utensile a sfacciatore)
F30
g0 x66 z2
g0 G42 x24 z2   
g1 z0
x26.66
x44.45 z-61.1
z-62.8
g2 x47.45 z-64.3 r1.5
g1 x61
g3 x64 z-65.8 r1.5
g0 G40 x66 z2

M30


Thanks for any info

best regards

Gianluca

Pages: 1