Topics

1

General Mach Discussion / Z axis Tolerance?

« on: July 17, 2013, 04:58:02 PM »

This is a first for me, my z axis has not reached its programmed zed depth (gcode z level in the minus). I was cutting 0.0625 inch thick material cutting to full depth but Mach would only go to 0.0621 one time then 0.0619 another. Is there tolerances that I am missing somewhere. Like I had mentioned I have never experience this before.

 Thanks MikeB

2

General Mach Discussion / Anyone experience this

« on: March 03, 2011, 12:40:37 PM »

I was running a program with 3 tool changes. (CAM used VisualMill), everything was running great until the last tool change. Start cutting when cut speed tripled, cut speed set at 50ipm. Has anyone experience change of speeds?

Thanks,
Mike