1
General Mach Discussion / servo drive connection
« on: April 08, 2007, 09:51:35 PM »
Hi,
I need some advice on connecting my Norwin drive to my pc to run on Mach3.
where do I connect to the drives (pic of cover attached) to my parallel cable.
I tried pin 2 and pin 3 to comd - and comd + without any joy.Its a Boxford ACL lathe
and the old ANC control is done.
thanks
Brian
I need some advice on connecting my Norwin drive to my pc to run on Mach3.
where do I connect to the drives (pic of cover attached) to my parallel cable.
I tried pin 2 and pin 3 to comd - and comd + without any joy.Its a Boxford ACL lathe
and the old ANC control is done.
thanks
Brian