Hello Guest it is December 04, 2021, 12:34:46 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - uuccimi

Pages: 1
1
General Mach Discussion / servo keep turning
« on: September 04, 2010, 09:40:38 PM »
my servos are hooked into a geckodriver g320 after I turn the power on the servos start running with stop, need help of how to fix this issue

2
General Mach Discussion / post processor
« on: September 10, 2008, 11:46:59 PM »
Good place to learn all about post processor!

3
VB and the development of wizards / VBScript to VB2005
« on: August 28, 2008, 12:15:59 PM »
Hi everyone!
VBScript that I want to change over to VB2005 code so I can make it an executable.  I know the code is similar, but there are a few differences and I am lacking VB2005 knowledge.  Also can someone tell me where can I learn to implement VB2005 code as Macro to Mach3?  I would greatly appreciate it!

4
LazyCam (Beta) / autocad vs. lazycam
« on: August 20, 2008, 10:23:38 AM »
How can open a DXF file onto LazyCam after was made out in Autocad
I did click OpenDXF in LazyCam but No Entities Found...

5
General Mach Discussion / cnc plasma table...
« on: August 14, 2008, 05:47:09 PM »
I'm in the middle of a 4"x8" Plasma table project,
I did download Mach R1.84.000 demo version
But I can't get the right configuration to make the torch to go on/off as I been seen in some youtube videos
Can anyone help me to go the right direction?

Some times the torch stays on even when is not cutting, other times move likes is cutting but no flame from the torch

regards,
uu

6
One on one phone support. / plasma table project...
« on: August 14, 2008, 05:38:52 PM »
I'm in the middle of a 4"x8" Plasma table project,
I did download Mach R1.84.000 demo version
But I can't get the right configuration to make the torch to go on/off as I been seen in some youtube videos
Can anyone help me to go the right direction?

Some times the torch stays on even when is not cutting, other times move likes is cutting but no flame from the torch

regards,
uu

 

Pages: 1