Hello Guest it is August 06, 2020, 01:08:26 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - skimpro

Pages: 1
1
General Mach Discussion / Driver test
« on: December 01, 2006, 11:27:01 PM »
I have been trying to get Mach 3 to work with my computer and gecko drives . I have checked everything I can think of and still can't get any motor movement. The one thing that seems odd is when I run a driver test a message comes up that says "Could not locate missing vectors". When I close the window and run the test again, the test will then work. Could this be a clue as to why I can't get anything to work?

2
Third party software and hardware support forums. / Microkinetics and Mach3
« on: November 11, 2006, 11:02:38 PM »
I have microkentics cnc and would like to switch the software to Mach 3. I have messed around with this for a few days and can't seem to get it to work. Has anyone been able to do this?

Pages: 1