Hello Guest it is March 28, 2024, 02:50:57 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - mattrulz123

Pages: 1
1
General Mach Discussion / newby setup problems
« on: August 07, 2008, 04:11:11 AM »
Hello just another newby here with a few problems.
i have built a tiny 3 axis mill for a trial machine to see what i could get from pc controllers. i have it running from my pc with another breed of controller and it seems ok but i cant get a single step out of mach3. i have a full version, licenced, and am using a xylotex 4 axis driver board. i have the pin outs set the same as the other config. and am using the same port and cables. is there something i may has missed in the setup? i have uninstalled and reinstalled 3 times thinking that i muffed that up somehow but am having no luck. any suggestions?

Pages: 1