1
Third party software and hardware support forums. / Removal of SmoothStepper
« on: September 21, 2016, 12:09:37 PM »
Hi all. I have had some problems with my mill. To help troubleshoot, I would like to bypass my USB SmoothStepper and run Mach3 from the parallel port of my computer. I have un-installed the SmoothStepper, and disconnected the USB cable and attached the parallel cable to the computer but Mach3 will not run because it is looking for the SmoothStepper. How do I get Mach3 to run conventionally? I am using a G540, and have Mach3 version R3.043.062.
Thanking you in advance,
Steve
Thanking you in advance,
Steve