Topics

1

Mach3 and G-Rex / [MACH3 with G100] ecode=777, ecode=790, ecode=813

« on: July 29, 2008, 03:19:28 PM »

 Dear all G100 user!

 Hi! I'm Kris.

 I'm using MACH3 with G100. And I have some problem.

 First I can launch firmware load when Grex shows me red light.
 And I can ping Grex always. 0% loss. So I'm sure I have static IP adress.

 But after motor tuning in Mach3, I always see error message as attached file.
 I did searched all topic about "ecode=777", "ecode=790" and "ecode=813".
 And I tried all firmware and plugin I can get. (But I'm not sure I have right...)


 Does anybody know about this problem?

 Please help me~~~