Topics

1

General Mach Discussion / Mach3 add on help

« on: July 28, 2007, 11:49:31 AM »

I just purchased the mach3 add-ons. I tried to open the .dat file but it says I need to go to control panel and create an association for it. I have no idea what to do. I know how to go to the file folder options in the control panel, but after that I am lost. I do not have mach3 installed on this computer so I need to save it and burn it to a cd and then load it to my computer that runs my mill.

Please help!!

Dan

2

General Mach Discussion / Cirlce Problem

« on: January 05, 2007, 03:39:57 PM »

Hello everyone. New here to the forum and Mach. Just retrofitted my mill. I am having problems with any type of circle. Looks like someone drew it by hand. Not at all symmetrical. I've tried adjusting backlash, it helped somewhat. I just don't know what else to look for.

Please help.

Dan