Hello Guest it is November 18, 2019, 03:12:30 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - ballard

Pages: 1
1
General Mach Discussion / Configuration Issues
« on: July 25, 2008, 01:32:29 PM »
I am trying to run a single stepper motor using Mach3, but I can't get the motor to run.  I am using a Campbell breakout board and a Geckodrive G203V driver with my motor.  I can't get the motor to respond to any Mach3 commands, but when I turned off the power to the breakout board and driver while Mach3 was still running, the motor turned a little bit.  It seems that things are hooked up, but I don't have Mach3 configured correctly.  Does anyone have any ideas on fixing this problem?

Pages: 1