Guest
Show Posts
1
General Mach Discussion / cnc stops :-(
« on: July 24, 2008, 11:36:50 PM »
hi all,
i recently installed a new tormach pcnc 1100. is run by mach3. it machines wonderfully until it stops. i traced the error to the g code. there seams to be a limit of 500 lines of g code that mach 3 will accept. is only
in the mach3 window that this occours, i can edit in notebook fine which suggests that it's loading.
is there something obvious i'm missing or is mach3 limited to 500 lines of g code.
has anyone else had this happen
brad m
i recently installed a new tormach pcnc 1100. is run by mach3. it machines wonderfully until it stops. i traced the error to the g code. there seams to be a limit of 500 lines of g code that mach 3 will accept. is only
in the mach3 window that this occours, i can edit in notebook fine which suggests that it's loading.
is there something obvious i'm missing or is mach3 limited to 500 lines of g code.
has anyone else had this happen
brad m