Hello Guest it is October 19, 2019, 06:32:34 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Chris

Pages: 1
1
General Mach Discussion / Plasma project
« on: October 23, 2006, 04:27:57 PM »
Hi,

I plan to construct a Plasma cutter and  I would like to use Mach3 software;  actually I am trying the demo version.

I am looking for a tutorial or guide to learn how to configure the various setup windows that I have found in the "Config" option.

Thanks for your support to my project.

Cristobal Munoz



 

Pages: 1