1
General Mach Discussion / strange behaviour / offset
« on: September 16, 2012, 01:56:47 PM »
I have a JCUT CNC with the USB interface.
from time to time, I get the machine not going to the requested coordinates input in g code. for example if I do z50, it may go z51. this happens very little but in the middle of long machining this is a big pb (see pics).
mach 3 shows the right coordinates. If I pause the machine and start again then if catches back the right coordinates.
any idea?
from time to time, I get the machine not going to the requested coordinates input in g code. for example if I do z50, it may go z51. this happens very little but in the middle of long machining this is a big pb (see pics).
mach 3 shows the right coordinates. If I pause the machine and start again then if catches back the right coordinates.
any idea?