1
General Mach Discussion / RS485/232 for axis
« on: October 18, 2006, 01:33:38 AM »
Hi All,
I am new in the Mach series CNC controlling.
I would like to use my AMC servo controllers for the axes.
It could be controlled via RS485 or RS 232 interface.
Can I use this type of communication? Or can I use the newer CAN BUS?
Regards István
I am new in the Mach series CNC controlling.
I would like to use my AMC servo controllers for the axes.
It could be controlled via RS485 or RS 232 interface.
Can I use this type of communication? Or can I use the newer CAN BUS?
Regards István