Hello Guest it is April 11, 2021, 07:06:24 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - boyvox

Pages: 1
General Mach Discussion / Setup units
« on: October 16, 2006, 05:29:56 PM »
When I change the Setup Units for the motor tuning dialog does that affect the G-Code I load in any way? I have G-Code in Inch units. If I hook up to a machine with Metric Ballscrews and set my motors correctly does Mach translate the inch-unit G-Code instructions to the correct turns for the metric screws? If so, does it slow down the program and/or do I lose accuracy?

Pages: 1