Topics

1

General Mach Discussion / :1448

« on: September 18, 2008, 04:24:47 PM »

When I open an *.nc file made with ArtCam, an entry in the Gcode listing right after the "%" simbol, starts with ":1448"...have to edit the code in order to run under Mach3. Is it a Mach3 or ArtCam problem?  After editing the code it runs fine without any apparent problem. Thanks for any clarification.

2

General Mach Discussion / Mach3 no motors running

« on: July 09, 2008, 02:18:08 PM »

My Router table is homemade,Solsylva plans. It runs fine with Mach2 but not with Mach3....!!! Have no home or limit switches and no Estop. My PC is a dual core 3.40 Ghz, 1Gb Ram running on Windows XP. What could be the problem? Any ideas are welcome and appreciated. Thanks.