1
General Mach Discussion / Connectivity Issues
« on: July 08, 2008, 05:25:33 AM »
Help Help!
I installd Mach 3 and done the port setups as required by my stepper driver but no joy! What am I missing? TurboCNC and KCam both get my machine runnig but Mach3 doesnt do a thing, not even some jitter.
Everything is powerd up well but it's like there's a settirng I cant get to. It also appears that the LPT port is passive or "off" under Mach. Any ideas or suggestions?
I run XP with SP3 @2000MHz with 512Ram
I installd Mach 3 and done the port setups as required by my stepper driver but no joy! What am I missing? TurboCNC and KCam both get my machine runnig but Mach3 doesnt do a thing, not even some jitter.
Everything is powerd up well but it's like there's a settirng I cant get to. It also appears that the LPT port is passive or "off" under Mach. Any ideas or suggestions?
I run XP with SP3 @2000MHz with 512Ram