Guest
Show Posts
1
SmoothStepper USB / Hi/Low Current
« on: December 25, 2009, 05:52:23 AM »
Hi
Can someone help me ??
When I run Mach3, direct on the lpt, my motor control goes Hi/Low Current fine.
But when I use Smoothstep v 1.2 Hi/Low Current don’t run
?
I use the same setup in Output Signal (see the attach file)
When I change Active Low Status in the setup I can get the,[img]http://Hi/Low Current to change,
But I cannot get it to change automatically like when I run direct on my LPT port.
Can someone help me ??
When I run Mach3, direct on the lpt, my motor control goes Hi/Low Current fine.
But when I use Smoothstep v 1.2 Hi/Low Current don’t run
?I use the same setup in Output Signal (see the attach file)
When I change Active Low Status in the setup I can get the,[img]http://Hi/Low Current to change,
But I cannot get it to change automatically like when I run direct on my LPT port.