Hello Guest it is March 28, 2024, 02:00:49 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Edison

Pages: 1
1
General Mach Discussion / In the Mach3Turn, how to get the lenght offset?
« on: December 29, 2008, 07:44:29 PM »
Hi all,
    In the Mach3Turn, how to get the lenght offset number?
    In the code "T0102 M6",
    Tool = GetSelectedTool()    'Tool=1
    but the lenght offset number howto get??

thanks!
Edison


2
General Mach Discussion / How to set the modbus output signal??
« on: October 14, 2008, 12:14:58 PM »
Hi,all:
   In the mach3 the modbus the input signal is set the port is 0 ,
but the output signal is mapping what??

Thanks for help!!

Edison

3
How to use the VB script instead of the Cycle start button?
Thanks!

Edison

4
General Mach Discussion / How to create Flash interface£¿
« on: August 17, 2008, 09:53:03 AM »
How to create Flash interface£¿£¿


Edison

5
General Mach Discussion / How to use the macros£¿£¿
« on: August 11, 2008, 11:58:00 AM »
In the macros, how to shield the Cycle Start £¿
In the macros, how to set up regularly interrupted£¿
In the macros, what functions can be applied£¿
What is the meaning of this function ¡°IsMoving()¡±£¿

Thanks!
Edison

6
General Mach Discussion / How to manufacture the plugins?
« on: July 31, 2008, 03:07:47 PM »
How to manufacture the plugins?
 Has any tool to be possible to provide?

Edison

7
General Mach Discussion / How to set encoder£¿
« on: July 29, 2008, 08:07:23 AM »
I use the 1024 resolution of the encoder,
How to associate it with the spindle£¿
Thanks£¡£¡

Edison

8
General Mach Discussion / Spindle speed
« on: July 04, 2008, 10:34:55 AM »
     My spindle motor is the maximum speed of 3,500 and the minimum was 200,
PWM control methods used, they were the corresponding duty cycle
90% and 10%, how to set up £¿£¿
     If I set a maximum speed of 3500, the minimum requirements for the duty ratio of 10%,
That the minimum speed so that I will become a 350, please help!
Thank you! !

Edison

Pages: 1